Isuzu Truck Dashboard Symbols and Meanings

This warning light should come on when the starter switch is turned to the “ON” position and then should go out after the engine is started and finishes with diagnostic.
If this warning light comes on while the engine is running, this alerts you to a problem with the engine electronic control system. Avoid driving at high speeds and promptly have the vehicle inspected at the nearest Isuzu Dealer.
If this warning light comes on either intermittently or continuously while driving, service is required. Even if the vehicle is drivable, and does not require towing, see your Isuzu Dealer as soon as possible for service of the system. Continued driving without having the system serviced could cause damage to the emission control system. It could also affect fuel economy and drivability.

This warning light should come on when the starter switch is turned to the “ON” position and then should go out after approximately 3 seconds.
If this warning light comes on while driving, immediately stop your vehicle at a safe place well clear of traffic and take the following actions.
● Stop the engine.
● Restart the engine. Check if the ABS warning light comes on and then goes out. If it does, there is no problem. The ABS operates normally.
● Move the vehicle slowly forward. Gradually increase the speed to 15 km/h (9 MPH). If the light goes off, the ABS is normal.
If the indicator light does not come on or go out, or comes on repeatedly, have the vehicle inspected/serviced at the nearest Isuzu Dealer as soon as possible.
Even if a problem has occurred in the ABS, the brakes will still work as normal brakes. In this case, the ABS has no influence on the operation of the brake system.

When the blind spot monitor (BSM) is turned off by using the user customization function on the MID, the BSM OFF indicator light on the instrument panel comes on.
This indicator light also comes on in the following cases.
● When the BSM or RCTA is not available due to an abnormality in another device or system in the vehicle.
● When the BSM or RCTA temporarily stops because the temperature of the radar sensors is extremely high or low, the warning message (“Radar unavailable”) is displayed on the MID for approximately 5 seconds, and then this indicator light comes on.
● When the BSM or RCTA temporarily stops due to dirt on the radar sensors or other factors, the warning message (“Radar clean-up”) is displayed on the MID for approximately 5 seconds, and then this indicator light comes on.
● When the BSM or the RCTA has malfunctioned, the warning message (“Radar failure”) is displayed on the MID for approximately 5 seconds, and then this indicator light and the master warning light come on at the same time. In this case, contact the nearest Isuzu Dealer.

When the parking aid system is turned off by pressing the parking aid system OFF switch, the parking aid system OFF indicator light on the instrument panel comes on.
This indicator light also comes on in the following cases.
● When the parking aid system is not available due to an abnormality in another device or system in the vehicle.
● When the sonar sensor cannot operate normally due to noise or other factors and the parking aid system temporarily stops, the warning message (“Sonar unavailable”) is displayed on the MID for approximately 5 seconds, and then this indicator light comes on.
● When the parking aid system temporarily stops due to dirt on the sonar sensors or other factors, the warning message (“Sonar clean- up”) is displayed on the MID for approximately 5 seconds, and then this indicator light comes on.
● When the parking aid system has malfunctioned, the warning message (“Sonar failure”) is displayed on the MID for approximately 5 seconds, and then this indicator light and the master warning light come on at the same time. In this case, contact the nearest Isuzu Dealer.

This indicator light comes on when the lane departure warning (LDW) system is off.

This indicator light comes on when the emergency lane keeping (ELK) system is off.

This indicator light comes on when the starter switch is turned to the “ON” position and goes out when preheating is completed. When the indicator light has gone out, the engine may be started.

When the starter switch is turned to the “ON” position, the indicator light should come on and change color from amber to green before it goes out 3 seconds later.
This indicator light comes on amber if there is a problem with the ASR or when you disengage the ASR using the ASR OFF switch.

The SVS indicator light will come on when the starter switch is in the “ON” position and the engine is not started, to let you know the bulb is working. The indicator light will go off after the engine starts.
If the indicator light comes on during operation, immediately contact the nearest Isuzu Dealer for inspection.

This indicator light comes on when the air cleaner element requires cleaning.

This warning light comes on when the fuel level in the tank becomes too low while the engine is running.
● If the low fuel warning light comes on, add fuel at the earliest possible time.
● If the vehicle runs out of fuel, an air bleeding procedure must be performed.

This warning light comes on if you continue driving the vehicle without refilling the AdBlue® tank when it is empty.

This warning light comes on whenever there is a problem with the electronic stability control (ESC) and/or hill descent control. When the ESC is operating, this warning light flashes.
This warning light also comes on when the 4WD switch is set to 4L (4WD low).
This warning light will also flash when only the traction control system (TCS) function is operating inside the ESC system.
When the ESC warning light does any of the following, the ESC may be faulty. Please contact the nearest Isuzu Dealer.
● When the ESC warning light remains on while driving.
● The ESC warning light does not come on when the power mode is switched to “ON” (models with passive entry and start system) or the starter switch is turned to the “ON” position (models without passive entry and start system).

This warning light comes on when the amount of engine oil is abnormal or when the engine oil is degraded. This warning light may come on earlier than the Maintenance Schedule.
If this warning light comes on, replace the engine oil and the engine oil filter immediately.

When the water in the water separator needs draining, the water separator warning light comes on.
Drain water following the instructions in the “Draining Water from the Fuel Filter” and make sure the warning light goes out.

This warning light comes on when the fuel filter element is clogged with dust and others.
If this warning light comes on, have the vehicle inspected/serviced at your Isuzu Dealer as soon as possible.

If this light flashes after the engine has started, there is something wrong with the transmission electronic control system.

When there is an abnormality in the LED headlight system, the LED headlight warning light comes on after the warning message is displayed on the MID for approximately 5 seconds.
Have your vehicle inspected at the nearest Isuzu Dealer.

This warning light comes on when there is an abnormality in the headlight automatic leveling.
Have your vehicle inspected at the nearest Isuzu Dealer.

This warning light comes on when the warning light and indicator light on the instrument panel is abnormal. At this time, a warning message is displayed on the MID for approximately 5 seconds.
If this warning light comes on, contact the nearest Isuzu Dealer.
This warning light comes on together with the following indicator lights to alert you that there is a problem with the vehicle.
● BSM OFF indicator light
● Parking aid system OFF indicator light
● Autonomous emergency braking OFF indicator light
● Lane departure warning OFF indicator light
● Emergency lane keeping OFF indicator light

This warning light comes on when there are abnormalities in the rear differential lock system.

This warning light comes on when there is an abnormality in the urea SCR system.

This warning light comes on when there is an abnormality in the electric power steering system.
If this warning light comes on, stop the vehicle in a safe place and restart the engine. If the warning light still comes on, have your vehicle inspected at the nearest Isuzu Dealer as soon as possible.

This indicator light stays on while the rear fog light is on.

When the operator regeneration of DPD is requested, this indicator light flashes.
When the operator regeneration starts, this indicator light changes from flashing to remaining on.
When the operator regeneration is completed, this indicator light turns off.

When the TCS is canceled by pressing the ESC OFF switch, the TCS OFF indicator light on the instrument panel comes on.
This indicator light also comes on when the 4WD switch is set to 4L (4WD low). When this indicator light does any of the following, the TCS function may be faulty. Please contact the nearest Isuzu Dealer.
● When the TCS OFF indicator light comes on during driving (when the ESC OFF switch is not operated).
● The TCS OFF indicator light does not turn on when the power mode is switched to “ON” (models with passive entry and start system) or the starter switch is turned to the “ON” position (models without passive entry and start system).

When the ESC is canceled by pressing the ESC OFF switch, the ESC OFF indicator light on the instrument panel comes on.
This indicator light also comes on when the 4WD switch is set to 4L (4WD low). When the ESC OFF indicator light does any of the following, the function may be faulty. Please contact the nearest Isuzu Dealer.
● When the ESC OFF indicator light comes on during driving (when the ESC OFF switch is not operated).
● The ESC OFF indicator light does not turn on when the power mode is switched to “ON” (models with passive entry and start system) or the starter switch is turned to the “ON” position (models without passive entry and start system).

This indicator light comes on when the idling stop system is deactivated.
This indicator light flashes in the following conditions. At this time, a warning buzzer (continuous beep) sounds and a message appears on the MID. These operations continue until the power mode is in “OFF” (models with passive entry and start system) the starter switch is set to the “LOCK” position (models without passive entry and start system), or the engine is started manually.
● If the engine hood is opened
● If an idling stop system or related system abnormality occurs
When the idling stop system OFF indicator light does any of the following, the idling stop system or related system may be faulty. Please contact the nearest Isuzu Dealer.
● When the idling stop system OFF indicator light flashes when the warning buzzer is not sounding.
● When the idling stop system OFF indicator light remains on when the power mode is switched to “ON” (models with passive entry and start system) or the starter switch is turned to the “ON” position (models without passive entry and start system).

This indicator light comes on when the autonomous emergency braking (AEB) is off.
This indicator light also comes on in the following cases.
● When the stereo camera system has malfunctioned.
● When the stereo camera has been temporarily stopped.