P0041: O2 Sensor Signals Swapped Bank 1 Sensor 2 / Bank 2 Sensor 2

What Does The P0041 Code Mean?

In a nutshell, a P0041 code means that the vehicle’s computer (the PCM or powertrain control module) has detected that the O2 oxygen sensors downstream from the catalytic converter have swapped wiring.

The vehicle’s PCM uses the multiple oxygen sensor readings to adjust how much fuel to inject into the engine for most efficient operation. The PCM monitors the engine sensor readings and if for example it puts more fuel into bank 2 of the engine but then sees that the bank 1 oxygen sensor is reacting instead of bank 2, that is the type of thing that triggers this code. For this DTC, the #2 O2 oxygen sensor will be downstream from (after) the catalytic converter. You may also experience the P0040DTC at the same time.

This code is uncommon and only applies to vehicles with engines that have more than one bank of cylinders. Bank 1 is always the bank of the engine that contains cylinder #1.

What Are The Symptoms Of The P0041 Code?

Symptoms of a P0041 engine code may include:

• Malfunction indicator lamp (MIL) illuminated solid or flashing
• Decreased engine power or rough running/idle
• Increased fuel consumption

What Are The Potential Causes Of The P0041 Code?

A P0041 DTC trouble code may be caused by one or more of the following:

• Oxygen sensors #2 wiring connectors swapped from bank to bank (most likely)
• O2 sensors #2 wiring crossed, damaged, and/or shorted
• Failed PCM (less likely)

How Can You Fix The P0041 Code?

A good first step is to find out if there was any recent work done in the area of the exhaust and O2 sensors. If there was, then there is a good chance that the most likely cause is the issue. That is, swapped wiring connectors for the second O2 sensor from bank 1 to bank 2.

Visually inspect all wiring and connectors leading to the second O2 sensors (these will likely be behind/downstream from the catalytic converters). Look to see if the wires are intact and not burned or twisted, etc. More than likely the connectors are swapped. If you are a DIY you could even try swapping these two oxygen wiring connectors as a first repair step, then clear the trouble codes and road test to see if the code returns. If it does not return then that was most likely the problem.

A next step would be to closely inspect the O2 wiring & connectors at the PCM end. Make sure wires are in the correct pin locations going into the PCM and it’s harness (refer to a vehicle specific repair manual for that). Be aware if there are swapped wires, damaged wires, etc. Repair as required.

If necessary, perform a continuity test of each individual wire from the PCM to the O2 sensor. Repair as necessary.

If you have access to an advanced scan tool, use it to monitor (graph) the O2 sensor readings and compare to specs. PCM failure is kind of a last resort and isn’t always DIY friendly. If the PCM has failed, you likely should take it to a qualified technician for repair or replacement.

Recommended Parts

Below are some recommended auto parts to help you address the trouble code affecting your vehicle and get it running smoothly again:

>>> O2 Sensor
>>> Twippo 372Pcs Waterproof Wire Connectors Kit
>>> ECU
>>> Auto Diagnostic Scanner iCarsoft VOL V2.0 for Volvo/SAAB

Note: During the purchasing process, please check carefully whether the part you want to buy fits your car!

Reference Sources

Diagnostic Trouble Code (DTC) Charts and Descriptions for P0041 – Page 12.