Chrysler B1BD3: Non Regular Operation Flag

Is your scanner showing Chrysler B1BD3?
No worries. We'll show you what it means and how to deal with it.

Presented by

Randy Worner

00:00/00:00

Chrysler B1BD3: Non Regular Operation Flag

OVERVIEW

Severity

Medium

DIY Difficulty Level

Intermediate

Repair Cost

$40-$200

Can I Still Drive?

Yes (Short-term only)

What Does The Chrysler B1BD3 Code Mean?

The Occupant Restraint Controller (ORC) is a sensing and diagnostic module that is responsible for monitoring and managing hard wired inputs, outputs, bussed messages and contains the vehicles Dynamics Sensor.

The module contains the pre-programmed logic to determine if and when a restraint is to be deployed. The ORC monitors these systems at ignition on and for most systems, continuously during vehicle operation, communicating relevant status and data over the bus. If the ORC detects a system failure or monitored value that is out of the allowable range, a corresponding DTC will be set and recorded and the Airbag Warning lamp will be commanded on.

In the event of a vehicle crash which exceeds a predetermined level, this may or may not include restraints deployment, crash data will be recorded and cannot be deleted. The Early Crash Sensors (Frontal Crash Sensors) are located on the front crossmember. The Remote Acceleration Sensors (B-Pillar Sensors) are located behind the trim of the B-Pillars. The Door Pressure Sensors (if equipped) are located in the front doors and the Yaw and Lateral Sensors are internal to the controller.